Canon imagePRESS C1 Service Manual - page 1006
Chapter 16
16-109
T-16-110
9. COLOR
COPIER > ADJUST > PASCAL
Subheading Contents
Level
OFST-P-Y/M/C/K
Adjust the offset for the test print reading signal (Y/M/C/K color) at PASCAL control for
automatic gradation correction (full correction).
Adjustment method
- When you set a larger value, the image density after automatic gradation correction (full
correction) becomes darker.
1
Adjustment range: -128 to +128
Standard value: 0
OFSTPLM
Not used
1
OFSTPLC
Not used
1
OFSTP2Y
Adjust the density at test print reading
Keep the Y density adjustment value when test print reading was performed (Media 2)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP2M
Adjust the density at test print reading
Keep the M density adjustment value when test print reading was performed (Media 2)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP2C
Adjust the density at test print reading
Keep the C density adjustment value when test print reading was performed (Media 2)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP2K
Adjust the density at test print reading
Keep the K density adjustment value when test print reading was performed (Media 2)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP2LM
Not used
1
OFSTP2LC
Not used
1
OFSTP3Y
Adjust the density at test print reading
Keep the Y density adjustment value when test print reading was performed (Media 3)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP3M
Adjust the density at test print reading
Keep the M density adjustment value when test print reading was performed (Media 3)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP3C
Adjust the density at test print reading
Keep the C density adjustment value when test print reading was performed (Media 3)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP3K
Adjust the density at test print reading
Keep the K density adjustment value when test print reading was performed (Media 3)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP3LM
Not used
1
OFSTP3LC
Not used
1