Canon imagePRESS C1 Service Manual - page 174
Chapter 2
2-80
F-2-282
2) Execute the followings in service mode; COPIER > FUNCTION >
MISC-P > PRINT, store the output papers in the service book case.
2) Execute P-PRINT.
Service mode > COPIER > FUNCTION > MISC-P > P-PRINT
3) Store the output paper in the service book case.
4. Attaching the caster cover
1) Temporary tighten the 2 screws (binding; M4X8) [1].
2) Attach the caster cover [2].
F-2-283
3) Tighten the screws in place.
2.2.46 Putting the Rating Plate.
0016-3331
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer)
- For Korea only
1) Put the rating plate [1] to the position as shown.
F-2-284
2.3 Unpacking and Installation (imagePRESS
C1 Series)
2.3.1 Points to Note About Installation (imagePRESS C1
series)
0016-9164
imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1+
2.3.2 Turning Off the Machine (imagePRESS C1 series)
0016-9165
imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1+
2.3.3 Installation Procedure (imagePRESS C1 series)
0016-9166
imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1+
1) Remove the upper left cover [1].
- 2 stepped screws [2]
F-2-285
2) Remove the reader fixing plate at the front [1] and the rear [2].
- 2 screws [3]
- Be sure to turn the caster cover to the position where it does not make
contact with the caster cover.
- Check to see if the adjuster is fixed properly.
[1]
[1]
[1]
[2]
Before mounting the decurler, install this equipment.
Turning Off the Main Power
Be sure to go through the following steps when turning off the main power
to protect the machine's hard disk:
1) Hold down the control panel power switch for 3 sec or more.
2) Follow the shut-down instructions on the screen. (The main power will
go off automatically.)
3) Disconnect the 2 power plugs of the machine (1 at the for the rear, 1 at
the left side).
[1]
[2]
[1]