Canon imagePRESS C1 Service Manual - page 1071
Chapter 16
16-174
UI-EPRNT
Set whether or not to display the expansion printing screen in the control panel.
This mode is used to set whether or not to display the expansion printing screen (EFI print screen)
in the control panel.
This is a specification for a user who does not desire to display the screen in the control panel.
2
Setting range
0: Do not display the screen.
1: Display the screen.
Standard value
1
UI-WEB
Set whether or not to display the Web browser screen in the control panel.
This mode is used to set whether or not to display the Web browser screen in the control panel.
This is a specification for a user who does not desire to display the screen in the control panel.
2
Setting range
0: Do not display the screen.
1: Display the screen.
Standard value
1
WEBV-SW
Set whether or not to prohibit the use of the WEBDAV function.
When this mode is set to 1(ON), the WEBDAV function becomes unavailable. (The WEBDAV
items are deleted from the following mode.
- User mode --> destination table specification setting --> registration of destinations --> file -->
"WEBDAV" in the protocol
- User mode --> "use the chunk divided transmission for WEBDAV transmission" in the
transmission specification setting items
2
Setting range
0: Use the WEBDAV function.
1: Do not use the WEBDAV function.
Standard value
0
[Reference]
Although the WEBDAV function is included in the main unit as a standard function, there are
cases when this function is not used in order to reduce the memory usage.
PASCL-TY
Set the paper type used for the automatic gradation correction (PASCAL).
This mode is used when executing PASCAL for the paper which is not recommended for the
destination.
2
Setting range
1: CLC-SK 80g paper (Countries other than USA/EU. Mainly Japan)
2: Hammermill 105g paper (for USA)
3: Neusiedler 100g paper (for EU)
Do not change the setting in a normal condition.
CARD-RNG
Set the number of cards available.
Set the number of cards available when using a card reader.
2
Setting range
1 to 1000
Standard value
1000
[Reference]
In the current condition, the starting number of the card is specified by
COPIER>FUNCTION>INSTALL>CARD, and the fixed number of cards is specified starting
from that number. (ex. fixed at 1000 cards)
WUEN-LIV
Set the activation interval after a sleep notice was provided from network.
Set the interval from when sleep activation was performed to the copier main unit from network
without sending a job to when the machine enters the sleep mode next.
2
Setting range
10 to 600
Standard value
15
(Unit: second) *10 seconds to 10 minutes
COPIER>OPTION>BODY
Subheading Contents
Level