Canon imagePRESS C1 Service Manual - page 130
Chapter 2
2-36
6) Close the toner replacement cover.
7) Pull the hopper [1] in the direction of the arrow until it stops.
F-2-63
8) Fold a sheet of A3 paper as shown in the figure and cover the supply
mouth [1] with the A3 paper [2].
F-2-64
9) Disconnect the 6 connectors [1], and free the cable from the cable guide
[2] and the wire saddle [3].
F-2-65
10) Disconnect the connector [1] and the other 7 connectors [2].
F-2-66
11) Remove the 5 screws [1].
F-2-67
12) Loosen the 2 process joint shafts [1] and the ITB joint shaft [2].
Points to Note when Pulling up the Hopper Unit
1, Be sure to check with eyes that the lock arm [1] on the lower left of the
hopper is hooked to the shaft [2] and the hopper unit is locked.
2, Be sure not to swing the hopper unit.
In the case the hopper unit is not fully locked, the hopper unit may drop.
MEMO:
The purpose of covering the supply mouth with a sheet of paper is to prevent
any contaminant from entering from the supply mouth [1].
[1]
[2]
[1]
A3
[1]
[2]
[1]
[2]
[3]
[1]
[1]
[2]
[1]