Canon imagePRESS C1 Service Manual - page 132
Chapter 2
2-38
F-2-73
18) Fold 2 to 3 sheets of A3 paper [1] in half as shown in the figure, and then
cover the drum with them.
F-2-74
2.2.11 Mounting the Balancing Cylinder
0012-9740
imagePRESS C1 P / imagePRESS C1
1) Take out the balancing cylinders from the attached packing box.
2) Remove the developing assembly cover [1].
- 1 screw [2]
F-2-75
3) Hold the gear at the developing assembly [1], and manually turn the de-
veloping rotary [2] counterclockwise, then with the balancing cylinder
upward, fix [A] and [B] aligned as instructed in the figure.
F-2-76
F-2-77
4) Open the 2 developing assembly fixing arms [1].
- 2 screws [2]
MEMO:
Paper is used for the purpose of preventing light-transmittance.
- In order to even the balance inside the rotary, the developing assembly
should be mounted by the following step:
balancing cylinder [1] > balancing cylinder [2] > M developing assembly
[3] > C developing assembly [4] > BK developing assembly [5] > Y
developing assembly [6]
- Attach the balancing cylinders onto the area where there is no toner supply
mouth.
[1]
A3
[1]
C
M
Y
Bk
[4]
[3]
[5]
[2]
[6]
[1]
balancing cylinder
balancing cylinder
In the case of turning the developing rotary, make sure that the developing
assembly fixing arm is fixed with the screw.
[2]
[1]
[1]
[2]
[A]
[B]