Canon imagePRESS C1 Service Manual - page 314
Chapter 5
5-35
driver etc.,)
9) Slide the scanner motor [5] in the direction shown by the arrow, and then
remove the belt [3] from the gear [4].
F-5-157
F-5-158
Points to Note When Attaching the Belt
When attaching the scanner motor, be sure that the timing belt [3] is hooked
onto the scanner pulley [1] and the motor shaft [2].
F-5-159
5.4.9.3 Removing the Scanner Motor (imagePRESS
C7000 Series)
0016-9499
Color Image Reader-H1
1) In case of the copyboard cover, detach the upper rear face plate 1 [1].
- 1 screw [2]
F-5-160
2) Detach the upper rear face cover 3 [1].
- 2 screws [1]
F-5-161
- 1 screw [1]
F-5-162
4) Remove the sub station upper rear cover [1] and the filter [2].
- 6 screws [3]
[1]
[2]
[2]
[1]
[5]
[4]
[3]
[2]
[3]
[1]
Be sure to tighten the 2 screws on the top while pressing the upper rear
cover in the direction of the arrow.
[1]
[2]
[1]
[1]