Canon imagePRESS C1 Service Manual - page 923
Chapter 16
16-26
6.ERR
F-16-15
-
1 to 50 (The larger the number is, the older the error is.)
-
-
-
- Error code
-
-
T-16-32
-
Not used
0007
delivery reversal sensor
PI9
- if not in high-speed duplex mode, the delivery sensor does not detect when a feed of 132.1
mm has been made after paper has reached the leading edge downstream roller with respect
to the activation of the read sensor.
- the delivery sensor does not detect paper when a feed of 50 mm has been made after the start
of feed during a switch-back operation.
0008
delivery reversal sensor
PI9
the delivery sensor detects paper when a feed of 161.9 mm has been made from the end of
reading the trailing edge.
0042
post-separation sensor
PI7
1st; stationary jam at the post-separation sensor
0043
registration sensor
PI1
1st; not reaching the registration sensor
0044
registration sensor
PI1
1st; stationary at the registration sensor
0045
feed sensor
PI8
1st; not reaching the read sensor
0046
feed sensor
PI8
1st; stationary at the read sensor
0047
delivery reversal sensor
PI9
1st; not reaching heat delivery sensor
0048
delivery reversal sensor
PI9
1st; stationary sensor at the delivery sensor
0071
wrong timing
-
error software timing
0073
wrong timing
-
the shift motor is faulty
0090
ADF open/closed sensor 1
PS502
the ADF is opened during operation
0091
ADF open/closed sensor 1
PS502
the ADF is opened during operation (while paper is in wait)
0092
DF cover open/closed sensor
PI6
A cover is opened during operation (while a drive mechanism is in operation).
0093
DF cover pen/closed sensor
PI6
A cover is opened during operation (in wait for paper).
0094
registration sensor, separation
sensor, feed sensor, delivery
reversal sensor
PI1,PI7,PI8,PI9 Paper is detected in the path while the 1st sheet is being picked up.
0095
original placement sensor, DF
cover open/closed sensor, ADF
open/closed sensor 1
PI5,PI6,PS502
A signal arrives indicating the start of pickup in the absence of an original in the tray or while
the machine is in an OPEN state.
Location Classification
0
main controller
1
Feeder
2
finisher
3
not used
4
reader unit
5
printer unit
6
PDL board (any of)
7
fax board
Code
Sensor type
Sensor notation
Description