Canon imagePRESS C1 Service Manual - page 1190
Chapter 16
16-293
F-16-31
16.7.1.2 COPIER List
0020-7015
imagePRESS C1+ (Printer) / imagePRESS C1+
1. PG
T-16-217
COPIER > TEST > PG
Subheading Contents
Level
TYPE
Input a type number for test print. Press the Start key and perform test print.
(Be sure to return to 0 after completing test print.)
1
Setting value
0: Image from CCD (normal print)
1 to 3: For development
4: 16 gradation
5: Halftone for the whole image
6: Grid
7 to 9: For development
10: MCYBk Horizontal stripes
11: For development
12: YMCBk 64 gradation
13: For development
14: Full color 16 gradation
15 to 200: For development
[Factory setting value / Value after RAM clear: 0]
TXPH
Set an image mode for test print.
1
Setting value
0: Error diffusion
1: Screen with small line number [133 to 190 lines]
2: Screen with large line number [200 to 268 lines]
3: Screen for COPY [around 220 lines]
4: Screen for REOS [no screen structure]
This mode is only valid for test print.
[Factory setting value / Value after RAM clear: 0]
THRU
Set whether or not to use the image correction table for test print.
1
Setting value
0: ON (Use the table.)
1: OFF (Do not use the table.)
[Factory setting value / Value after RAM clear: 0]
DENS-Y/M/C/K
Adjust the density of each color for test print (TYPE=5).
1
Setting range: 0 to 255
When you increase the setting value, the density becomes higher.
[Factory setting value / Value after RAM clear: 128]
COLOR-Y/M/C/K
Set whether or not to display each color at each type.
For example, to output a single M color, set COLOR-M to 1 and set other items to 0.
1
Setting value
0: Do not display the color.
1: Display the color.
[Factory setting value / Value after RAM clear: 1]
F/M-SW
Set whether to perform full-color output or mono-color output for PG output.
1
Setting value
0: Full-color output
1: Mono-color output
[Factory setting value / Value after RAM clear: 0]
PG-PICK
Select a cassette used for test print.
1
Setting value
1: Cassette 1
2: Cassette 2
3: Cassette 3
4: Cassette 4
5: Side deck
6: Manual feeding
7 to 8: Not used
[Factory setting value / Value after RAM clear: 1]
Counter
Option
Function
I/O
NETWORK
READY
+/-
OK
Display
Adjust
Result (OK/NG)
PING
IP address input
0 .
0
Test