Canon imagePRESS C1 Service Manual - page 1039
Chapter 16
16-142
T-16-144
COPIER>FUNCTION>MISC-P
Subheading Contents
Level
P-PRINT
Print out the service mode setting value.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
It takes approximately 15 seconds before printing starts.
1
P-PRINT
Print out the service mode standard value
Execute the print out of the service mode standard value.
Left/right margin adjustment value (COPIER > ADJUST > FEED-ADJ > BLK-SML2) for the
second side on small size is added as an output item.
When executing P-PRINT with a printer model, an item for second-side left/right margin
adjustment value on small size was missing. Thus, this item is added in this change.
1
This item applies to the upgraded device or later (DCON Ver11.03 or later, Cont Ver24.04 or
later).
KEY-HIST
Print out the control panel key input history.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
1
HIST-PRT
Print out the jam history and error history.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
1
TRS-DATA
Transfer the data received in memory to the box.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
1
USER-PRT
Print out the user mode list.
Operation method
1) Select this item.
2) Press the OK key to perform printing.
It takes approximately three seconds before printing is performed.
1
LBL-PRNT
Print out the service label.
Operation method
1) Set the A4/LTR paper in Cassette 1.
2) Select this item.
3) Press the OK key to perform printing.
It takes approximately 15 seconds before printing is performed.
1
PRE-EXP
Check the lighting operation of the post-exposure lamp (LED).
Operation method
1) Press an item to highlight it.
2) Press the OK key. Each operation is performed for a few seconds and stops automatically.
3) Press the OK key to perform printing.
Reference
When a failure occurs to the photosensitive drum caused by the lighting operation of the post-
exposure lamp, rotate the drum.
1
D-PRINT
Print out the service mode (DISPLAY).
This is a mode to print out only the items displayed in the DISPLAY service mode (excluding
items output by P-PRINT/LBL-PRINT/HIST-PRINT and ALARM).
Operation method
1) When selecting the item to highlight and pressing OK key, the operation is started.
1
1ATVC-EX
Forcibly execute the primary ATVC.
Execute this mode when replacing the ITB or ITB unit.
Operation method
1) Select this item.
2) Press the OK key to start operation. The operation completes after approximately one minute.
1