Canon imagePRESS C1 Service Manual - page 461
Chapter 7
7-112
F-7-267
7) Cut the excess charging wire using a wire cutter.
8) Pinch the edge of the charging wire tension spring [1] using tweezers, and
hook it to the charging electrode [2].
In case of the pre-transfer charging assembly, hook the spring to the pin
located in the front.
F-7-268
After hooking the spring, check the following:
- The charging wire [1] is not bended or twisted.
- The charging wire [1] is fitted in the groove [2] on the upper side of the
charging wire positioning.
F-7-269
In case of the primary charging assembly, lead the charging wire as indicated
below.
F-7-270
9) Assemble the primary charging assembly in the reverse steps.
10) Clean the charging wire using lint-free paper moistened with alcohol so-
lution.
11) Mount the wire cleaner.
Be sure the direction when mounting the wire cleaner.
7.14.42.3 After Replacing the Primary Charging Wire
0014-3685
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Execute the primary charging wire cleaning from service mode.
(primary charging wire cleaning: COPIER > FUNCTION > CLEANING
> WIRE-CLN)
(FRONT)
(REAR)
[1]
[2]
[3]
[1]
[2]
(FRONT)
(REAR)
[1]
[2]