Canon imagePRESS C1 Service Manual - page 450
Chapter 7
7-101
F-7-208
Points to Note When Mounting the ITB Drive Unit
1) Route the harness [1] through the hole of the harness guide [3] and the
edge saddle [2].
2) Route the 3 harnesses [4] through the hole [5] of the ITB drive side plate.
F-7-209
7.14.25 Secondary Transfer Outside Roller Unit
7.14.25.1 Preparation for Removing the Secondary
Transfer Outer Roller Unit
0013-9761
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
2) Pull out the fixing/feeding unit toward you.
7.14.25.2 Removing the Secondary Transfer Outer Roller
Unit
0013-9762
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the lever [1].
- 1 screw [2]
F-7-210
2) Detach the feeding front cover [1].
- 2 screws [2]
F-7-211
Points to Note When Attaching the Feeding Front Cover
The feeding front cover has the button to open the lower cover of the fixing/
feed unit.
To prevent the bar at the end of the button from being broken, take care to
attach the feeding front cover so that the bar is in proper position.
3) Detach the feeding upper front cover [1].
- 2 screws [2]
F-7-212
4) Disconnect the connector [1], and remove the 3 screws [2].
5) Press the gear [3] in the direction of the arrow to pull out the secondary
transfer outer roller unit [4].
6) Disconnect the 2 connectors [5].
[2]
[1]
[1]
[1]
[2]
[3]
[4]
[4]
[5]
[1]
[2]
[1]
[2]
[1]
[2]