Canon imagePRESS C1 Service Manual - page 886
Chapter 15
15-23
15.3 Error Codes (SEND)
15.3.1 End Code Items
0012-0888
imagePRESS C1 P / imagePRESS C1
T-15-7
Cause
Remedy
# 001
Indicates that different sizes of originals were scanned while media size is not set
as mix mode switch.
Check the original and the settings, and then repeat the operation.
Indicates that different sizes of originals were scanned by duplexing mode while
media size is not set as mix mode switch.
Check the original and the settings, and then repeat the operation.
# 009
Indicates paper-out.
Supply media.
Indicates that the cassette is not set properly.
Set the cassette properly.
# 037
Indicates that reception failed due to low available memory.
Delete the error or unnecessary documents to increase available memory.
# 099
Indicates that copy/print was interrupted.
Repeat the copy/print job.
# 701
Indicates that Department ID registered at introduction of the job does not exist
or password is changed.
Enter the correct department ID or password from numerical keypad and then send
the job again.
Indicates that Department ID or password is changed during execution of the job
or non-regular ID print job reception setting is deactivated.
Contact the system administrator.
# 703
Writing is not possible because the image area of memory is full.
1) Wait a while. Try again after another transmission job has ended.
2) Delete the files from the box. If the symptom still appears, turn off and then on
the machine's main power.
# 711
Indicates that the Box memory is full.
Delete the documents within the Box.
# 712
Indicates that the Box document is full.
Delete the documents within the Box.
# 749
Indicates the failure of job execution as service call is displayed.
Turn OFF the main power switch, wait for 10 sec or more, and then turn ON the
main power switch. If the machine still does not operate properly, turn OFF the
main power and plug off the power cord. Then contact the Service.
# 759
Indicates that an error occurred when sending the URL of the Box in which
document is stored.
Contact the system administrator.
# 816
Indicates that the print job failed as it exceeded the value to restrict the printable
side set in the departmental ID administration.
Contact the system administrator.
# 849
Indicates that the machine failed to deliver the device information as the external
phone (destination device) is under other job operation.
Deliver the device information again after job by the external phone (destination)
# 850
Indicates that the machine failed to deliver the device information as the display
related to the transmitted information in the external phone (destination device) is
under operation.
Check the device information that was not delivered, and then deliver it again.
# 851
Indicates that there is insufficient memory.
Check the memory level of the machine and delete unnecessary documents in the
box.