Canon imagePRESS C1 Service Manual - page 1014
Chapter 16
16-117
16.4.3 SORTER
16.4.3.1 SORTER List
0011-9643
imagePRESS C1 / imagePRESS C1+
T-16-120
16.5 FUNCTION (Operation/Inspection Mode)
16.5.1 COPIER
16.5.1.1 COPIER List
0011-9644
imagePRESS C1
1. INSTALL
T-16-121
SORTER>ADJUDT
Subheading Contents
Level
PNCH-HLE
Adjust the length between the paper edge and the position of a punched hole.
1
Setting range
-4 to 2
[Factory setting value / Value after RAM clear: 0]
COPIER>FUNCTION>INSTALL
Subheading Contents
Level
STIR-Y/M/C/K
Stir developer in the developing unit (Y/M/C/K).
Select an item to highlight it and press the OK key. The operation starts.
1
STIR-4
Stir four-color developer in order.
Operation method
Select an item to highlight it and press the OK key. The operation starts.
1
SPLY-H-Y/M/C/K
Perform initial supply from the toner container (Y/M/C/K) to the toner buffer.
Select an item to highlight it and press the OK key. The operation starts.
1
SPLY-H-4
Perform initial supply from the four-color toner cartridge to the toner buffer.
Operation method
Select an item to highlight it and press the OK key. The operation starts.
1
CARD
Make a setting for installation of the card reader.
1 to 2001 [Factory setting value / Value after RAM clear: 0]
Enter the card number and press the OK key. (Numbers for the number of cards specified by
COPIER>OPTION>BODY>CARD-RNG in Level 2 starting from the entered number are
available.)
The card control information (a section ID and password) is initialized.
1
KEY
Recognize the control key function.
0: Do not recognize the control key function.
[Factory setting value / Value after RAM clear: 0]
1: Recognize the control key function.
1) Select COPIER>INSTALL>KEY and enter "1".
2) Turn OFF/ON the main power switch. (The control key function is recognized.)
1