Canon imagePRESS C1 Service Manual - page 329
Chapter 5
5-50
F-5-256
20) For the subsequent steps, see step 20 to 33 in 'Removing the Scanner
Drive Wire' (in case of imagePRESS C1 Series).
5.4.13.4 Attaching the Scanner Drive Wire (imagePRESS
C1 Series/imagePRESS C7000 Series)
0014-1578
imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1+
1) Put the ball of the wire into the hole on the drive pulley[1] and wind the
wire around it (inner side 4 turns, outer side 5 turns), then fix it with the
tape etc. At this time, wind it with the wire retaining fixture [2] inside
(same as shown below).
2) Hook the wire onto each pulley and then fix one end onto the hook[3] at
the left side and the other end onto the hook[4] at the right side temporar-
ily.
3) Temporarily fix the wire fixing plate [2] to the primary mirror mount [5].
4) Attach the reader upper frame.
F-5-257
F-5-258
5.4.13.5 Adjustment of Positions of the Mirror 1, 2 Mount
(imagePRESS C1 Series/imagePRESS C7000 Series)
0014-1619
imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1+
1) Arrange the pin position for rear on the mirror positioning tool (FY9-
3009-040) from the initial position to the operational position.
F-5-259
2) Arrange the pin position for front on the mirror positioning tool from the
initial position to the operational position.
[1]
[2]
[2]
[4]
[4]
[5]
[3]
[3]
[1]
[1]
[2]
[2]
[4]
[4]
[5]
[A]
[A]
[B]
[B]
[C]