Canon imagePRESS C1 Service Manual - page 128
Chapter 2
2-34
2) Open the decurler upper unit [1].
F-2-50
3) Insert the 3 claws [2] of the outer delivery roller cover [1] into the hole of
the decurler, and then move it in the direction of the arrow.
4) Fix the external delivery roller cover [1] using the screw (P-tight; M4X8)
attached with the tape inside the external delivery roller cover.
F-2-51
5) Close the decurler upper unit.
6) Close the decurler front cover.
2.2.9 Decurler Open / Close Angle Adjustment
0015-6364
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the outer delivery roller cover.
2) Remove the delivery Tray.
3) Open the decurler front cover [1]
F-2-52
4) Remove the screw [1], slide the decurler upper cover [2] in the direction
of the arrow to detach.
F-2-53
5) Remove the upper left cover [1] of the decurler.
- two screws [2]
F-2-54
6) Detach the decurler upper left cover [1].
- 1 screw [2]
F-2-55
7) Remove the adjusting shaft [1].
- 1 resin ring [2]
F-2-56
8) Open the decurler. Insert the adjusting shaft [1] into either hole of [A] to
[C], and fix it with the plastic ring.
A: 30 deg
B: 20 deg
C: 15 deg
Detach the outer delivery roller cover before removing the delivery tray.
In the case of using flash memory, change the angle of the decurler opening
because the USB flash memory comes into contact with the main machine.
[1]
[1]
[2]
[3]
[1]
[2]
[1]
[2]
[1]
[1]
[2]
[1]
[2]