Canon imagePRESS C1 Service Manual - page 978
Chapter 16
16-81
OFSTPLM
Not used
1
OFSTPLC
Not used
1
OFSTP2Y
Adjust the density at test print reading
Keep the Y density adjustment value when test print reading was performed (Media 2)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP2M
Adjust the density at test print reading
Keep the M density adjustment value when test print reading was performed (Media 2)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP2C
Adjust the density at test print reading
Keep the C density adjustment value when test print reading was performed (Media 2)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP2K
Adjust the density at test print reading
Keep the K density adjustment value when test print reading was performed (Media 2)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP2LM
Not used
1
OFSTP2LC
Not used
1
OFSTP3Y
Adjust the density at test print reading
Keep the Y density adjustment value when test print reading was performed (Media 3)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
OFSTP3M
Adjust the density at test print reading
Keep the M density adjustment value when test print reading was performed (Media 3)
1
Adjustment range: -128 to +128
Standard value: 0
When replacing the reader controller, input the value written on the service label once again.
COPIER>ADJUST>PASCAL
Subheading Contents
Level