Canon imagePRESS C1 Service Manual - page 122
Chapter 2
2-28
2.2 Unpacking and Installation
2.2.1 Points to Note Before Starting the Work
0012-6079
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
When installing the machine, keep the following in mind.
2.2.2 Unpacking
0012-6120
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Unpack the machine, and remove the plastic cover.
2) While pushing against the leaf spring [2] in the grip opening [1] on the
right side of the machine using a flat-blade screwdriver, fit in the 2 grips
[3].
F-2-20
3) Hold the grips on the left side (front, rear) of the machine, lift the machine
slightly to remove the 2 pads [1].
At this time, move the plastic bag in the direction of the arrow.
(machine weight: about 310 kg)
F-2-21
- If the machine is moved from a cold to warm place, condensation can
occur. If condensation occurs, image faults can occur. Before starting the
work, unpack the machine, and leave it for 1 hour or more so that it becomes
used to the room temperature.
(Condensation: If a piece of metal s moved from a low to warm place, the
moisture in the air around them becomes cooled rapidly, turning into drops
of water on the metal surfaces.)
- Since the main body weighs approximately 310 kg, unpacking must be
done by 4 or more persons.
- Be sure to turn the 2 adjusters (2 on the front) at the bottom of the machine
clockwise to release. When moving the machine, adjusters may come off
due to vibrations. Be careful not to lose the adjusters.
Check to make sure that the rear of the claw [4] of the grip is hooked on the
plate.
Check to be sure that the caster [1] has not dropped off the skid [2] and has
not ridden over the edge [3] of the side.
[1]
[3]
[4]
[4]
[2]
[1]
[1]
[2]
[3]