Canon imagePRESS C1 Service Manual - page 135
Chapter 2
2-41
F-2-86
6) Push the 2 developing assembly fixed arms [1] in the direction of [A], set
them in the direction of [B] to fix.
- 2 screws [2]
F-2-87
F-2-88
2.2.13 Mounting the Developing Assembly
0012-9754
imagePRESS C1 P / imagePRESS C1
1) Take out the developing assembly (Yellow, Magenta, Cyan, and Black)
from the attached packing box.
2) Hold the gear at the developing assembly [1], and manually turn the de-
veloping rotary [2] counterclockwise, then with the installed color up-
ward, fix [A] and [B] aligned as instructed in the figure.
[1]
[2]
[3]
[1]
[A]
[A]
[B]
[B]
[1]
[2]
[2]
MEMO:
When touching the developing assembly, check to make sure that your
hands are free of foreign matter (especially metal pieces), then start the
work. (If there is foreign matter on your hand, it may cause image fault.)
The developing positioning sheet for each color is attached to [A] of the
respective developing rotary. Attach the developing assembly according to
each positioning sheet.
If turning the developing rotary clockwise while the developing assembly is
fitted, the toner blocking sheet which is attached to the sleeve of the
developing assembly may come off because of intervention with the
photosensitive drum. The developing rotary must be turned
counterclockwise.
C
K
M
Y
[A]