Canon imagePRESS C1 Service Manual - page 139
Chapter 2
2-45
F-2-100
F-2-101
3) Open the 2 developing assembly fixing arms [1].
- 2 screws [2]
F-2-102
4) Remove the protective sheet [1] attached at the toner supply mouth of the
developing rotary.
F-2-103
5) Set an A3-size sheet, and remove the desiccant [1] and protection part [2]
in the condition where the developing cylinder of the developing assem-
bly is placed on the upper side.
F-2-104
6) Manually turning the developing cylinder gear [1] 5 to 6 times in the di-
rection of the arrow, to check if there is any scar on its surface and also
make the starter in the unit even out.
F-2-105
7) Remove the 2 tapes [1] to remove the sponges[2].
In the case of turning the developing rotary, make sure that the developing
assembly must be fixed with the screw.
[1]
[2]
[A]
[B]
[2]
[1]
[2]
[1]
Keep in mind not to touch the developing cylinder.
After the above operation, change the direction of the developing assembly
so that the taped-sponge comes upward.
Make sure to remove the sponges [2].
[1]
[1]
[2]
[1]
[2]