Canon imagePRESS C1 Service Manual - page 206
Manual is about: imagePRESS C1 Series
of
1265
Chapter 2
2-112
2. Connecting to the Host Machine
1) Remove screw [2] to remove the blind plate [1] from the power cord mount of the paper deck.
F-2-418
2) Install the supplied AC input connector [1] in two steps ([A] > [B]).
F-2-419
3) Secure the ground cable [1] using the screw with toothed washer [2].
F-2-420
4) Using two binding screws (M4X4)[1], install the relay harness unit [2] to the rear side panel [3] of the paper deck.
5) Insert the bind locks of the cable ties into the holes (at [A] shown below) on the rear side panel to secure the relay harness.
6) Connect the connectors at both ends of the relay harness unit to the heater connector [4] and AC power connector [5] respectively.
[2]
[1]
[1]
[A]
[B]
[1]
[2]