Canon imagePRESS C1 Service Manual - page 727
Chapter 13
13-8
F-13-17
13.4.2 After Replacing the Fixing Roller
0013-3398
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
- Apply approx. 20 mg of grease (Molykote HP-300; CK-8012) to the bush-
ing inner periphery [1] and external periphery [2] so as to make white
coating on all the area.
Purpose: Prevent noise (rasping sound).
F-13-18
- The grease is attached on the end of the fixing roller [1] when fixing the
greased bushing with the fixing roller, so wipe it off.
F-13-19
13.4.3 After Replacing the Fixing Belt
0013-3404
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
Before installing a new belt, apply silicon oil (S-20; FY9-6011) to the
marked area of the pressure pad cover (within the radius of about 200 mm
from the center).
Apply silicon oil to the pressure pad cover, after soaking lint-free paper into
the oil to the extent that the oil does not drip from the paper.
F-13-20
[1] pressure pad cover
13.4.4 After Replacing the Fixing Cleaning Belt
0013-3403
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
Set the value clear '0' for the following service counters.
- COPIER> COUNTER> DRBL-1> FX-WEB
13.4.5 After Replacing the Fixing Belt / Pressure Pad
Cover
0014-6124
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
Before installing a belt, apply silicon oil (S-20; FY9-6011) to the marked
area of the pressure pad cover (within the radius of about 200 mm from the
center).
Apply silicon oil to the pressure pad cover, after soaking lint-free paper into
the oil to the extent that the oil does not drip from the paper.
F-13-21
[1] pressure pad cover
13.4.6 When replacing pressure belt
0020-8935
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1 (CUSTOM) / im-
agePRESS C1+ (Printer) / imagePRESS C1+
1) Apply silicone oil to the following areas:
- Surface of oil coating roller: 0.1ml
- Surface of inlet roller: 0.1ml
[Tools to be used]
- Silicone oil (Parts Number: FY9-6011)
- Dropper
1-1) Make a paper slip to be used for applying the oil. Cut A4 paper into 1/8
(approx.), and then fold the piece into three.
1-2) While turning the oil coating roller, apply 0.1ml of silicone oil at the
center [1] (30mm inside from the both ends) on the surface of the roller
A
B
20mm
150mm
[2]
[1]
[1]
[1]
[1]