Canon imagePRESS C1 Service Manual - page 1069
Chapter 16
16-172
LPD-PORT
Set a LPD port number.
2
Setting range
1 to 65535
Standard value
515
Reference
LDP port is the network port for TCP/IP communication at printing via network.
ORG-A4R
Use it to set a special paper size not recognized when the ADF is in use.
2
With machines for INCH/AB configuration, image formation is executed correctly by setting the
size of the special paper that fails to be recognized at original pickup from the ADF.
Settings
0: A4R (default) 1: FOLIO-R
When detecting the A4R original in the ADF, it converts to the original size that was set in this
item to execute image formation using the original size after conversion.
ORG-FLSC
Use it to set a specific paper size not recognized when the ADF is in use.
2
With machines for INCH/AB configuration, image formation is executed correctly by setting the
size of the special paper that fails to be recognized at original pickup from the ADF.
settings
0: Foolscap-R (default);
1: Officio-R;
2: Folio-R;
3: Australian Foolscap-R;
4; Ecuadorian Officio-R;
5; Argentine Officio-R;
6: Argentine Legal-R;
7: Government Legal-R;
8: Mexican Officio-R
When detecting the FOOLSCAP size in the ADF, it converts to the original size that was set in
this item to execute image formation using the original size after conversion
PDF-RDCT
Set whether or not to reduce and send the image for reception transfer (transmission in the PDF
format).
2
Reduce and send the image when converting the image received by FAX or iFAX into the PDF
format and performing transmission by e-mail or file.
Setting range
0: Convert the image into the PDF format, but do not reduce it for reception transfer.
1: Convert the image into the PDF format, and reduce it for reception transfer.
Standard value
0
REDU-CNT
Control the switching of the density adjustment method.
Control whether or not to perform density adjustment considering toner volume restriction.
2
Setting range
0 to 1
Standard value
1
REBOOTSW
Set whether or not to perform reboot when the E240 error occurs.
In the current specifications, reboot is performed when the E240 error occurs.
(Reasons: Continuous rotation deteriorates the durability performance of the engine. It cannot be
also denied that it may cause an error to the engine.)
However, when reboot is performed automatically, jobs in the PDL disappear, which has been
causing complaints in the field. Therefore, this mode is used to set whether or not to automatically
perform reboot when the E240 error occurs.
2
Setting range
0: Perform reboot automatically when the E240 error occurs.
1: Do not perform reboot automatically when the E240 error occurs.
Standard value
0
COPIER>OPTION>BODY
Subheading Contents
Level