Canon imagePRESS C1 Service Manual - page 1054
Chapter 16
16-157
1. BODY
COPIER>OPTION>BODY
Subheading Contents
Level
PO-CNT
Set ON/OFF of the electric potential control function.
1
Setting range
0: OFF
1: ON
Standard value
1
MODEL-SZ
Switch the fixed and variable display and ADF document size detection.
1
Setting range
0: AB (6R5E)
1: INCH (5R4E)
2: A (3R3E)
3: AB/INCH (6R5E)
Standard value
0: AB(6R5E) For Japan
1: INCH(5R4E) For North, Central and South America
2: A(3R3E) For Europe
3: AB/INCH(6R5E) For Asia, Oceania and South America
FIX-TEMP
Switch the plain paper down sequence table.
1
Setting range
0: Default
1: Fixing is prioritized
2: Productivity is prioritized
Standard value
0
The setting value becomes valid after the main power switch is turned OFF/ON.
Usage:
Select '0' when giving preference to the image quality (fixing), '2' when giving preference to the
speed (productivity).
PASCAL
Set if using the contrast electric potential and gradation correction data obtained by automatic
gradation correction (full correction) control, or not.
1
Setting range
0: Use the data.
1: Do not use the data.
2: Reserve (same operation as 1)
3: Reserve (same operation as 0)
Standard value
1
The setting value becomes valid after the main power switch is turned OFF/ON.
For printer model, be sure to make the setting value 0 at installation.
CONFIG
Select several system software stored in the hard disk, change the nation/area, paper size.
1
Procedure:
1) Select
2) Select the item to change.
3) Press the +/- key. (Each press changes the setting.)
4) Display the contents to be needed, press OK key.
5) Turn off and then back on the main power switch.
XXYYZZAA
XX: country (e.g., JP=Japan)
YY (*): language (e.g., ja=Japanese)
ZZ: (*) destination (e.g., 00=Canon)
AA: paper size series (00=AB; 01=inch; 02=A; 03=inch/AB)
*: Cannot change the setting.