Canon imagePRESS C1 Service Manual - page 196
Chapter 2
2-102
1. Installing to the paper deck
1) Disconnect the connector [1] of the paper deck from the host machine
F-2-392
2) Release the paper deck [1] from the host machine, and then press down the latch plate [2] of the paper deck housing with your finger to open the housing [3].
(A: Rear, B: Front)
F-2-393
3) Remove three screws [1], and then detach the right cover [2] of the paper deck to the direction of the arrow shown.
F-2-394
4) Remove four screws [1] and two other screws [2], and then detech the rear cover [3] of the paper deck.
When installing the heater to the paper deck, take the following precautions.
a. The AC power plug of the host machine must have been removed from the outlet.
b. Install the heater after installing the host machine and paper deck.
c. Use correct screws (length and diameters) at correct positions.
[1]
[A]
[3]
[2]
[1]
[B]
[1]
[2]