Canon imagePRESS C1 Service Manual - page 432
Chapter 7
7-83
7.14 Parts Replacement Procedure
7.14.1 Process Unit
7.14.1.1 Preparation for Sliding the Processing Unit
0014-1119
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front cover.
2) Detach the processing unit cover.
3) Lift the hopper unit.
7.14.1.2 Sliding the Processing Unit
0014-1120
imagePRESS C1 P / imagePRESS C1
1) Remove the drum fixing mount [1].
- 1 screw [2]
F-7-103
Points to Note When Attaching the Drum Fixtures
When attaching the drum fixtures, be sure not to rotate the drum clockwise.
If the drum is rotated clockwise, which is the reverse of its normal direction,
the scoop-up sheet may become soiled and toner may scatter.
2) Disconnect the 6 connectors [1], and remove the cable from the cable
guide [2] and the clamp [3].
F-7-104
3) Disconnect the 1 connector [1] and the 7 connectors [2].
F-7-105
4) Remove the 5 screws [1].
F-7-106
5) Loosen the 3 processing link shafts [1].
Check to see that processing link shafts can be moved back and front.
F-7-107
6) Bring down the fixing feeding release lever [1] in the direction below.
F-7-108
7) Slide the fixing feeding unit [1].
When sliding the fixing feeding unit, be sure to completely disconnect the
connectors [1] in step 3.
[1]
[2]
[1]
[2]
[3]
[1]
[1]
[2]
[1]
[1]
[1]