Canon imagePRESS C1 Service Manual - page 123
Chapter 2
2-29
4) Hold the grips on the right side (front, rear) of the machine, lift the ma-
chine slightly to remove the 2 pads [1] and the plastic bag.
F-2-22
5) Take out the 2 slope plates [2] from the middle of the skid [1].
F-2-23
6) Remove the 2 pins taped to the back of the slope plate.
7) Turn over the slope plate [1], and fit it as shown; then, match the pin holes
of the skid and the pin holes of the slope plate, and connect them with 2
pins [2].
F-2-24
8) Align the casters [1] with the slope plates, and unload the machine by slid-
ing it on the slope plates with holding the grip [3].
F-2-25
9) Turn the adjusters [1] in the direction shown by the arrow to lock them in
place.
F-2-26
10) While pushing against the leaf spring [1] with a flat-blade screwdriver,
remove the 2 grips [2].
F-2-27
11) Remove the packing tape from the machine.
12) Fit the 2 grip face covers (A) [1] over the grip openings.
Don't incline the machine too much, it could loose its balance.
Do not align the casters [2] with the slope plates.
If unloading the machine by aligning the casters [2] with the slope plates,
the casters may run off the slope plates
[1]
[1]
[2]
[1]
[2]
[3]
[1]
[2]
[1]
[1]
[2]