Canon imagePRESS C1 Service Manual - page 437
Chapter 7
7-88
Points to Note when attaching the Primary Corona Assembly Pad
Holder
When attaching the primary corona assembly slider [1] and the primary co-
rona assembly pad holder [2], fit them in the direction shown by the figure
below.
F-7-133
7.14.7 Primary Corona Slider
7.14.7.1 Preparation for Removing the Primary Corona
Assembly Slider
0013-9731
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front cover.
2) Detach the processing unit cover.
3) Lift the hopper unit.
4) Remove the primary corona assembly. (page 7-86)Reference [Remov-
ing the Primary Corona Assembly]
5) Remove the primary grid plate. (page 7-87)Reference [Removing the
Primary Grid Plate]
6) Remove the primary corona assembly pad holder. (page 7-87)Reference
[Removing the Primary Corona Assembly Pad Holder]
7.14.7.2 Removing the Primary Corona Assembly Slider
0013-9732
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Turn the primary corona assembly slider [1] in the direction shown by the
arrow to remove it.
When removing, be sure not to cut the corona wire [2].
F-7-134
Points to Note when attaching the Primary Corona Assembly Slider
When attaching the primary corona assembly slider [1] and the primary co-
rona assembly pad holder [2], fit them in the direction shown in the figure.
F-7-135
7.14.8 Pre-transfer Charging Assembly
7.14.8.1 Preparation for removing the Pre-transfer
Corona Assembly
0014-0562
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front cover.
2) Detach the processing unit cover.
7.14.8.2 Removing the pre-transfer corona assembly
0014-0563
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the pre-transfer corona assembly [1].
- 1 connector [2]
- 1 screw [3]
F-7-136
7.14.8.3 After Replacing the Pre-transfer Charging
Assembly
0014-3686
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
Execute the service mode (pre-transfer charging wire cleaning: COPIER >
FUNCTION > CLEANING > WIRE-CLN).
7.14.9 Pre-Transfer Corona Pad Holder
7.14.9.1 Preparation for Removing the Pre-transfer
Corona Assembly Pad Holder
0013-9733
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
[1]
[2]
[1]
[2]
[1]
[2]
[2]
[3]
[1]