Canon imagePRESS C1 Service Manual - page 1033
Chapter 16
16-136
F-16-29
7. PANEL
T-16-140
- Numbers and names of input keys
T-16-141
COPIER>FUNCTION>PANEL
Subheading Contents
Level
LCD-CHK
Check the blank dot area in the LCD display.
Operation method
1) Select this item and press the OK key to start operation.
The front side of the touch panel lights in white - black - red - green - blue colors in order
repeatedly. (Make sure this condition.)
2) Press the Stop key to stop the operation. (Press the Clear key for a printer mode.)
1
LED-CHK
Check the LED light in the control panel.
Operation method
1) Select this item and press the OK key to start operation.
The LEDs light up in order.
2) Press LED-OFF to stop the operation.
1
LED-OFF
Check the LED light in the control panel.
Operation method
1) Select this item to stop the LED-CHK operation.
1
KEY-CHK
Check the input of keys.
Operation method
1) Select "KEY-CHK" to display a number/name of the entered key.
2) Press a key to be checked. If there is no problem, the relevant character is displayed in the touch
panel. (Refer to an attached table.)
3) Select "KEY-CHK" again. The checking stops.
1
TOUCHCHK
Adjust the coordinate position of the analog touch panel.
Operation method
- Adjust the pressing position in the touch panel to the LCD coordinate position
- When you replaced the LCD, execute this service mode.
1) Select "TOUCHCHK" to highlight it, and press the OK key.
2) Press the nine "+"s displayed in the touch panel in order. Adjustment is completed.
1
Key
Indication on the screen
0 to 9, #, *
0 to 9, #, *
Reset
RESET
Stop
STOP
User mode
USER
Start
START
Power save
STAND BY
Clear
CLEAR
ID
ID
Help
?
Counter Check
BILL
[1]