Canon imagePRESS C1 Service Manual - page 1112
Chapter 16
16-215
SSH-SW
Set whether or not to activate the SSH server.
Make this setting to specify whether or not to activate the SSH server when activating the main
unit.
2
Setting range
0: Do not activate the SSH server when activating the main unit.
1: Activate the SSH server when activating the main unit.
Standard value
0
SSH server does not start by changing the setting value to 1(ON) while activating the main unit.
The setting value becomes available after turning the power switch OFF/ON.
Reference
SSH is the abbreviation of 'Secure Shell'. The communication between digital accessory (DA) and
iR device is encrypted to avoid being read from the outside.
RMT-LGIN
Set whether or not to permit remote login to the SSH server.
Make this setting to specify whether or not to permit remote login from the remote host (SSH
client: digital accessory) to the SSH server debug console.
2
Setting range
0: Do not permit remote login to the SSH server.
1: Permit remote login to the SSH server.
Standard value
0
This item becomes available only when the setting value of
RE-PKEY
Set whether or not to recreate the SSH server pair keys.
Make this setting to specify whether or not to recreate the SSH server pair keys when activating
the main unit.
2
Setting range
0: Do not recreate the SSH server pair keys when activating the main unit.
1: Recreate the SSH server pair keys when activating the main unit.
Standard value
0
This item becomes available only when the setting value of
Reference
In the case that the main item is set to '1(recreate)', SSH server host recreates the pair keys
(confidential/disclosure key) during task activation (power OFF/ON), and implements the output
to key file and storage into HDD. Encryption algorithm (DSA) and the length of key (512bit) are
fixed.
It may take about three to four minutes more than usual to start the copier body due to this
procedure.
COPIER>OPTION>BODY
Subheading Contents
Level