Canon imagePRESS C1 Service Manual - page 201
Chapter 2
2-107
F-2-405
9) Insert the AC cord [1] into the hole of the cord mount [2], and then secure the ground cable [3] to the cord mount using a screw with toothed washer.
10) Secure the AC cord [1] to the cord mount using a screw [5] with flat spring .
F-2-406
11) Hang the left-hand hook [1], and then secure the cord mount [3] to the host machine using two binding screws (M4X4) [2].
12) Connect the connector of the AC cord to the connector [4] on the host machine.
F-2-407
13) Install the rear-cover of the host machine using eight screws.
14) Reatach the exterior covers of the paper deck in the following sequence;
[1] Top cover (take care not to have the cables caught) [M4X8: 2pcs.]
[2] Front-upper cover (insert the connector) [M4X8: 3pcs]
[3] Rear cover [M3X8: 2pcs, M4X8: 4pcs.]
[4] Right cover [M4X8: 3pcs.]
15) Manually slide the paper deck to the left place in aside of the host machine.
16) Stick the power supply label [1] on the rear panel of the paper deck.
[1]
[2]
[4]
[3]
[2]
[1]
[5]
[2]
[3]
[1]
[4]