Canon imagePRESS C1 Service Manual - page 592
Chapter 9
9-55
F-9-152
7) Move the 2 mounts [1] in the direction of the arrow [A] respectively, and
then, remove them in the direction of the arrow [B].
- 3 fixing screws [2] of the fixing heater
- 2 screws [3] (loosen)
F-9-153
After removing 3 screws [1], make sure the three terminals [3] of the fixing
main heater and the fixing sub-heater will be unattached to the three bosses
[2].
Leaving the terminals attached to the bosses may cause the terminals to be
damaged, when removing the fixing roller unit.
F-9-154
8) Remove the fixing roller unit [1] in the direction of the arrow.
F-9-155
9) From the fixing roller unit, remove the fixing main heater/fixing sub heat-
er [1] in the direction of the arrow.
F-9-156
Points to Note when Attaching / Detaching the Fixing Main Heat-
er / Fixing Sub-Heater
Hold the white part [2] of the fixing main heater and the fixing sub-heater [3]
when handling them.
To hold other parts of these heaters place a piece of paper [1] underneath
them.
F-9-157
9.7.23 Inlet Heater
9.7.23.1 Preparation for Removing the Fixing Belt Inlet
Heater
0014-0227
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
2) Pull out the fixing/feeding unit toward you.
3) Remove the fixing belt unit. (page 9-38)Reference [Removing the Fix-
ing Belt Unit]
9.7.23.2 Removing the Fixing Belt Inlet Heater
0014-0228
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the 2 heater fixing holders [1].
- 2 screws [2]
F-9-158
2) Pull out the fixing belt inlet heater [1] in the direction of the arrow.
[4]
[4]
[4]
[2]
[3]
[1]
[2]
[2]
[A]
[A]
[3]
[3]
[1]
[B]
[B]
[1]
[2]
[3]
[1]
[3]
[3]
[1]
[2]
[1]
[1]
[1]
[2]
[3]
[1]
[1]
[2]
[2]