Canon imagePRESS C1 Service Manual - page 528
Chapter 8
8-63
- 1 screw [3]
F-8-121
3) Remove the pre-fixing/feeding unit [1].
3-1) Move it in the direction of the arrow [A], and then, lift it in the direction
of the arrow [B] to remove.
- 3 E-rings [2]
- 2 bearings [3]
- 1 gear [4]
F-8-122
Points to Note When Mounting the Pre-Fixing/Feeding Unit.
In the case of mounting the pre-fixing/feeding unit, make sure to execute af-
ter passing the harness [1] through a hole of the edge saddle [2].
F-8-123
8.10.7.3 Removing the Pre-Fixing/Feeding Unit
0020-5129
imagePRESS C1+ (Printer) / imagePRESS C1+
1) Disconnect the connector [1].
2) Remove the fixing pin [2].
- 1 screw [3]
F-8-124
3) Remove the pre-fixing/feeding unit [1].
3-1) Move it in the direction of the arrow [A], and then, lift it in the direction
of the arrow [B] to remove.
- 3 E-rings [2]
- 2 bearings [3]
- 1 gear [4]
F-8-125
Points to Note When Mounting the Pre-Fixing/Feeding Unit.
In the case of mounting the pre-fixing/feeding unit, make sure to execute af-
ter passing the harness [1] through a hole of the edge saddle [2].
F-8-126
8.10.8 Fixing/Feeder Unit
8.10.8.1 Preparation for Pulling/Removing the Fixing/
Feeding Unit
0014-0086
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
8.10.8.2 Pulling/Removing the Fixing/Feeding Unit
0014-0087
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
[Pulling out the fixing/feeding unit]
1) Turn the handle in the direction of the arrow.
[2]
[3]
[1]
[A]
[B]
[1]
[2]
[3]
[2]
[2]
[3]
[4]
[1]
[2]
[2]
[3]
[1]
[A]
[B]
[1]
[2]
[3]
[2]
[2]
[3]
[4]
[1]
[2]