Canon imagePRESS C1 Service Manual - page 184
Chapter 2
2-90
F-2-341
44) Attach the 2 S-B board fixing plates [2] to the S-B board [1].
- 2 screw (TP; M3X6) [3]
F-2-342
45) Insert the ZJ-A board [2] into the slot found at the back side of S-B board
[1], and then tilt to the direction of the arrow.
F-2-343
46) Fix the ZJ-A board [1].
- 2 screws (TP; M3X6) [2]
F-2-344
47) Insert the S-B board [1] into the original position and then, fix it.
- 2 screws [2] (Attach the screw removed in the step 42).
F-2-345
48) Attach the controller PCB guide [1].
- 4 screws [2]
F-2-346
49) Attach the main controller cover 2.
50) Attach the power unit station rear cover 1.
51) Connect one side of the reader communication cable [1] into the reader
I/F connector found at the right side of the power unit station.
[1]
[2]
[1]
[3]
[2]
[1]
[2]
[1]
[2]
Make sure that the S-B board is inserted toward the rear side properly.
Be sure to check that the LAN-bar-B PCB [3] has surely been secured after
securing the controller PCB guide [1] with the screw.
[1]
[2]
[2]
[2]
[2]
[1]
[3]
[3]