Canon imagePRESS C1 Service Manual - page 690
Chapter 11
11-45
- When saving an image to USB memory, time stamps and user signatures cannot be added.
- Operation from remote UI and image preview are not supported.
- The only supported USB memory is that which conforms to USB compliance tests.
- USB memory with security settings (passwords, etc.) are not supported.
- USB memory connected via extension cables or USB hubs are not supported.
- While USB memory is connected, the device cannot enter deep sleep.
- While the device is in deep sleep, USB memory cannot be connected.
- The maximum number of files (including folders) that can be displayed in a USB memory is 1,000.
- Non USB memory devices are not supported.
- The default setting permits the use of USB memory.
Supported devices
The device that supports USB memory related function is as follows.
1) Colour devices
None
2)BW devices
iR3245 series
Scan to USB memory (supported outside of Japan and Europe)
Scanned documents can be saved directly to USB.
F-11-68
Box To USB memory (supported outside of Japan and Europe)
Image data stored in box saved to USB memory.
F-11-69
USB memory To Print: Print PDF/TIFF/JPEG. (supported outside of Japan and Europe)
Links with PDF direct print option to print out image data stored in USB memory.
- Maximum printable size is 2GB.
- Settings for enlarged/ reduced printing and N-up printing available.
The following functions and settings cannot be used.
- Multiple document printing, split binding and cover insert functions
- Editing functions such as coupled printing and page deletion, etc.
- Preview
- Free size paper printing
- If a USB memory device is connected while the device is in deep sleep, the unit will not be able to detect the USB memory, so the USB removal button will not be
displayed (it will be grayed out). Therefore, the USB memory should be removed, then, after touching the control panel and activating the display, reconnect the USB
memory.
- When a MEAP application, etc., is being used, the settings are sometimes not changed. In that case, the following statuses (factory settings) need to be changed in
user mode.
[User mode]>[System administrator settings]>[USB settings]>[Use USB host]: ON
(factory shipment default: ON)
[User mode]>[System administrator settings]>[USB settings]>[Use MEAP driver as USB external memory device]:[OFF]
(factory shipment default: OFF)
Until a scan job has been completely written into the USB memory, the next scan operation cannot be carried out. In particular, even if a document has been scanned
in, it takes time to write in searchable PDF, etc., so subsequent scanning operations cannot start till the current job has been completely written in.