Canon imagePRESS C1 Service Manual - page 452
Chapter 7
7-103
F-7-219
4) Move the 2 potential guide plate arms [1] in the direction of [A] first, and
then, move them in the direction of [B].
F-7-220
5) Lift the tension roller pressure lever [1] in the direction of the arrow.
F-7-221
6) Remove the idler roller [1] in the direction of the arrow.
- 1 bearing [2]
- 1 wheel [3]
F-7-222
7) By holding the 1cm areas [2] from the both edges of the ITB [1], pull it
out in the direction of the arrow to remove.
Take care not to touch the surface of the ITB with hands.
F-7-223
Once removed, the ITB should be stood on its end on paper spread on the
floor.
7.14.28 Primary Transfer Roller
7.14.28.1 Preparation for Removing the Primary Transfer
Roller
0013-9715
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front cover.
2) Detach the process unit cover.
3) Lift the hopper unit.
4) Remove the primary charging assembly. (page 7-86)Reference [Re-
moving the Primary Corona Assembly]
5) Remove the pre-transfer charging assembly. (page 7-88)Reference [Re-
moving the pre-transfer corona assembly]
6) Remove the drum unit. (page 7-89)Reference [Removing the Drum
Unit]
7) Pull out the fixing/feeding unit.
8) Remove the intermediate transfer unit. (page 7-100)Reference [Remov-
ing the Intermediate Transfer Unit]
9) Remove the ITB cleaning unit. (page 7-99)Reference [Removing the
ITB Cleaning Unit]
10) Remove the ITB. (page 7-102)Reference [Removing the ITB]
7.14.28.2 Removing the Primary Transfer Roller
0013-9716
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Shift the primary transfer roller pressure arm [1] in the direction of the ar-
row.
[1]
[2]
[3]
[1]
[1]
[A]
[A]
[B]
[B]
[1]
[1]
[1]
[2]
[3]
[1]
[2]
[2]