Canon imagePRESS C1 Service Manual - page 751
Manual is about: imagePRESS C1 Series
of
1265
Chapter 14
14-16
Do the following steps to remedy the above symptom:
1. Check to see if there is any mistake of attaching the seal support plate (front, rear).
Check if the seal support plate [2] is below the scoop-up sheet [1], and make a correction if it is not.
In the case of mistakenly attaching, perform operation to attach after replacing the new scoop-up sheet.
F-14-20
2. Clean the potential control plate (A).
Using lint-free paper, remove the waste toner found at the both sides of potential guide plate.
F-14-21
image sample
[1]
[2]
[1]
[1]
[1]
[2]
[1]
[1]
[2]