Canon imagePRESS C1 Service Manual - page 434
Manual is about: imagePRESS C1 Series
of
1265
Chapter 7
7-85
F-7-115
4) Remove the 5 screws [1].
F-7-116
5) Loosen the 3 processing link shafts [1].
Check to see that processing link shafts can be moved back and front.
F-7-117
6) Bring down the fixing feeding release lever [1] in the direction below.
F-7-118
7) Slide the fixing feeding unit [1].
When sliding the fixing feeding unit, be sure to completely disconnect the
connectors [1] in step 3.
F-7-119
8) Hold down the claw [1] and then slide the fixing feeding unit.
F-7-120
9) Slide the processing unit [1].
F-7-121
10) Place the A3 paper [1] onto the drum as shown in the figure.
This is for the purpose of light shielding.
[1]
[2]
[1]
[1]
[1]
[1]
[1]
[1]
[1]