Canon imagePRESS C1 Service Manual - page 159
Chapter 2
2-65
F-2-208
3) Check the folliwing setting
Service mode: COPIER > OPTION > BODY > CLCONFIG
Make sure that this setting is set to "0".
2.2.27 Turning the Main Power ON
0016-9484
imagePRESS C1 P / imagePRESS C1
1) Connect the power cable with the inlet on the main body.
2) Connect the 2 power plugs (1 for the backside, and 1 for the left side of
the machine) of the machine to different power outlets, and turn on the
main power [1].
F-2-209
2.2.28 Points to Note at the Main Power OFF
0018-5931
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
2.2.29 Checking the Drum Temperature Switch
0012-7215
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Set the drum temperature switch in accordance with the installation envi-
ronment.
In the high humidity environment (*), set the drum temperature switch [1]
to the lower side (H).
* High humidity condition is a condition of which the value of absolute
humidity in a machine is 10 g or more.
Service mode > COPIER > DISPLAY > ANALOG > ABS-HUM
In a high humidity environment (*), set the drum temperature switch [1]
to the lower side ('H').
* High humidity environment is a condition in which the value of the
absolute humidity (COPIER > DISPLAY > ANALOG > ABS-HUM) in
a machine in the service mode is more or equal to 10g.
Before turning the main power on, be sure to remove the packing materials.
ON
OFF
[1]
Turning Off the Main Power
Be sure to go through the following steps when turning off the main power
to protect the machine's hard disk:
1) Hold down the control panel power switch for 3 sec or more.
2) Follow the shut-down instructions on the screen. (The main power will
go off automatically.)
3) Disconnect the 2 power plugs of the machine (1 at the for the rear, 1 at
the left side).
ON
OFF
[1]