Canon imagePRESS C1 Service Manual - page 188
Chapter 2
2-94
F-2-357
3) Detach the hopper cover (Right) [1].
- 1 screw [2]
F-2-358
4) Remove the right door small cover [1].
- 1 cover rubber piece [2]
- 2 screws [3]
F-2-359
5) Fit the 2 stepped screws [1] of the card reader mounting kit to the host ma-
chine.
F-2-360
6) Put the cable [1] through the hole [2] of the card reader mounting base;
then, fix it to the card reader [3] and the card reader mounting base [4].
- 1 toothed washer [5]
- 1 screw (TP; M4x8) [6]
F-2-361
7) Disconnect the relay connector [1].
F-2-362
8) Connect the connector [1] of the card reader and the connector [2] of the
host machine.
F-2-363
9) Fit the cut-off [1] of the card reader on the stepped screws [2] that have
been fitted in place in step 5).
10) Fit the card reader [3] in the direction of the arrow, and fix it in place.
- 1 screw (TP; M4x8) [4]
The removed right door small cover [1] will no longer be used.
[1]
[2]
[1]
[2]
[1]
[2]
[3]
[3]
[1]
The removed relay connector [1] will no longer be used.
[1]
[2]
[3]
[4]
[6]
[5]
[1]
[1]
[2]