Canon imagePRESS C1 Service Manual - page 1058
Chapter 16
16-161
BMLNKS-Z
Make a setting to switch the attribute flag attached to the reception BMLinkS printing.
1
Setting range
0: For SCAN photo mode
1: For PDL photo mode
2: For SCAN character mode
3: For PDL character mode
Standard value
0
Reference
0: For SCAN photo mode
A black character is printed in a black color which consists of four colors. An image is printed by
error diffusion. The color tone is brighter than 2.
1: For PDL photo mode
A black character is printed in a black color which consists of four colors. An image is printed by
screen processing.
2: For SCAN character mode
A black character is printed in a single black color. The color tone in the photo area is different
from the tone printed by 0. (It may be difficult for an amateur to recognize the difference.) An
image is printed by error diffusion.
3: For PDL character mode
A black character is printed in a single black color. An image is printed by screen processing.
IMGC-ADJ
Switch the "hide" or "not hide" of the image adjustment items.
Switch the "hide" or "not hide" of the image adjustment items executed by a system administrator.
When "not hide" is selected, the following four items are displayed in the system administrator
setting.
- Curl correction volume
- Adjustment of the air volume for the paper separation fan
- Adjustment of the image position
- Adjustment of the secondary transfer voltage
1
Setting range
0: Hide
1: Do not hide
Standard value
0: Hide
ARCDT-SW
ON/OFF of ARCDAT
Select whether or not to perform ARCDAT control.
ON [0]: Reflect the ARCDAT result to LUT.
OFF [1]: Do not reflect the ARCDAT result to LUT.
1
Setting range
0 to 1
0: Control ON
1: Control OFF
Standard value
0: Control ON
TR-CON
Switch-over of toner reduction value
1
Setting range
0 to 2
0: Normal object (for normal object), text line (for text line)
1: Normal object (for normal object), text line (for normal object)
2: Normal object (for text line), text line (for text line)
Standard value
0
F-BLT-RT
Measure at E007 (fixing belt displacement error) occurrence
Specify the host machine operation at E007 occurrence.
1
Setting range: 0 to 1
0: Automatic restore does not take effect at power OFF/ON.
1: Automatic restore takes effect at power OFF/ON.
Standard value 0
This item applies to the upgraded device (DCON Ver11.03 or later and Cont Ver24.04 or later).
COPIER>OPTION>BODY
Subheading Contents
Level