Canon imagePRESS C1 Service Manual - page 367
Chapter 7
7-18
F-7-19
[1] Primary Transfer Roller
[2] Secondary Transfer Inside Roller
[3] Secondary Transfer Outside Roller
DC-CON: DC Controller
HUM1: Environment Sensor
UN5: Pickup Driver PCB
1. Primary Transfer ATVC
The primary transfer ATVC determines the primary transfer voltage in order to obtain the target transfer current at the time of the transfer.
The primary transfer ATVC control has the following two control types: the full ATVC control executed by facing the developing assembly of each color to the
drum (considering the drum potential variation, and the state with the influence of the developing bias), and the partial potential control executed without facing
the developing assembly to the drum (the state without the influence of the developing bias).
a. Startup Condition
Full Potential Control
- At the warm-up rotation after the power is ON.
- When executing the PASCAL control.
- At the last rotation after passing 500 sheets.
Partial Potential Control
- At the warm-up rotation.
b. Description
T-7-8
Sequence Operation
Description
1
Apply the constant current
By applying the constant current to the primary transfer roller, feedback the voltage data of the primary transfer
roller to the DC controller.
DC-CON
HV2-SUB
HVT2
HVT4
J3050
J3150
[1]
[3]
J1189
J203
J202
J1188
J205
J201
TR1_OUT
TR2_OUT
J1177
UN-5
J1412
ENV_TEMP
HUM1
J556
J1407
TEMP
[2]