Canon imagePRESS C1 Service Manual - page 313
Chapter 5
5-34
5.4.8.4 Scanner Parts Replacement Procedure
(imagePRESS C1 Series/imagePRESS C7000 Series)
0014-2024
imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1+
Parts:
CCD unit / copyboard glass / scanning lamp / inverter PCB
Procedure
Execute the following Service Modes in order.
1) COPIER > ADJUST > CCD > W-PLT-X
COPIER > ADJUST > CCD > W-PLT-Y
COPIER > ADJUST > CCD > W-PLT-Z
(Enter the white level data for the white plate)
2) COPIER > ADJUST > CCD > EC-R
COPIER > ADJUST > CCD > EC-G
COPIER > ADJUST > CCD > EC-B
(Color correction of the copyborad glass)
5.4.9 Scanner Motor
5.4.9.1 Preparation for Removing the Scanner Motor
(imagePRESS C1 Series/imagePRESS C7000 Series)
0013-9958
imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1+
1) Remove the copyboard glass. (page 5-16)Reference [Removing the
Copyboard Glass]
5.4.9.2 Removing the Scanner Motor (imagePRESS C1
Series)
0013-9959
imagePRESS C1 / Color Image Reader-H1 / imagePRESS C1+
1) Detach the reader rear cover [1].
- 1 connector [2]
- 5 screws [3]
F-5-151
2) Detach the reader rear upper cover [1].
- 1 screw [1]
- 1 embossed section [3]
F-5-152
3) Remove the reader I/F cable [2] from the 2 wire saddles [1].
F-5-153
4) Remove the I/F board shielding plate [1].
- 8 screws [2]
- 2 screws [3]
F-5-154
5) Remove the 4 screws [1] and then bring down the connector mount [2] to
the front.
F-5-155
6) Remove the cable [2] from the 2 wire saddles [1], and then remove the re-
use band [3].
7) Disconnect the connector [4], and then remove the cable [6] from the edge
saddle [5].
F-5-156
8) Remove the 3 screws [1] and the 2 springs (using a fine flat blade screw
[1]
[2]
[3]
[2]
[3]
[1]
[1]
[2]
[2]
[3]
[2]
[1]
[2]
[1]
[1]
[1]
[2]
[3]
[5]
[6]
[4]