Canon imagePRESS C1 Service Manual - page 1063
Chapter 16
16-166
CMD-PORT
Use it to turn off/on the T.O.T (TUIF over TCP/IP) sync type command communication port.
2
Turns on/off the inquiry/response (sync) type command communication port for TUIF over TCP/
IP.
settings
0: off (default); 1: on
For service NAVI, set the value as '1' when connecting the PC and main body by crossing cable.
MEMO:
T.O.T (TUIF over TCP/IP)
Communication protocol between embedded application presentation (UI) and applications
within the device including COPY/SEND/BOX etc., (Canon original protocol)
MODELSZ2
Provide global measures for plate document size detection.
When 1 is set for this mode, INCH/AB (global) mode is provided regardless of the MODEL-SZ
setting, which is a flag to switch INCH or AB.
2
Settings
0: normal (Detection size for each destination) (default) ; 1: Inch/AB mix detection
- This is for individual user, not used normally.
- For different-sized originals detection (Inch/AB-configuration), original size sensor is required.
SZDT-SW
Switch the mode from the CCD size detection to the photo size detection for plate document size
detection.
2
settings
0: Size detection by CCD (Default) ; 1: Size detection by photo sensor
- This is for individual user (glare protection), not used normally.
- When the value is set as '1', original size detection at open/close of the pressure plate is not
performed. For detection of the original size (without lightning the scanning lamp), original size
sensor (photo sensor) is required.
UISW-DSP
Set 'hide' or 'not hide' of the SW to switch the display to the user screen.
Set 'hide' or 'not hide' of the SW to determine which of the normal screen or the simple screen
(Lawson type) is used.
The following types of screen are available.
- Screen that has the function similar to a standard machine
- Screen that has limited function like the screen used at Lawson
A user (a store manager) specifies 'hide' or 'not hide' of the SW to switch these screens.
2
Setting range
0: Hide
1: Do not hide
Standard value
0
NS-CMD5
Restrict the use of CRAM-MD5 authentication in SMTP authentication. (NoSasl-Challenge
response authentication mechanism; MD5 message digest algorithm)
Make this setting when restricting the use of CRAM-MD5 authentication in SMTP
authentication.
2
Setting range
0: Dependent on SMTP
1: Do not use the authentication.
Standard value
0
NS-GSAPI
Restrict the use of GSSAPI authentication in SMTP authentication. (NoSasl-Generic Security
Service Application Program Interface)
Make this setting when restricting the use of GSSAPI authentication in SMTP authentication.
2
Setting range
0: Dependent on SMTP
1: Do not use the authentication.
Standard value
0
COPIER>OPTION>BODY
Subheading Contents
Level