Canon imagePRESS C1 Service Manual - page 577
Chapter 9
9-40
(around the center). This makes the mounting work easier.
F-9-68
- Take care so that the bearing of the steering roller does not run over the
frame.
9.7.3.3 Preparation for Removing the Fixing Separation
Roller Ball Bearing
0014-8539
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
2) Pull out the fixing/feeding unit toward you.
3) Remove the fixing belt unit. (page 9-38)Reference [Removing the Fix-
ing Belt Unit]
9.7.3.4 Removing the Fixing Separation Roller Ball
Bearing
0014-8541
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the 2 fixing separation roller ball bearings [1].
- 4 E-rings [2]
- 2 gears [3]
- 1 dowel pin [4]
- 2 bearings [5]
- 2 spacers [6]
F-9-69
9.7.4 Fixing Roller
9.7.4.1 Preparation for Removing the Fixing Roller
0014-0186
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Open the front door.
2) Pull out the fixing/feeding unit toward you.
3) Remove the fixing main heater/fixing sub heater. (page 9-54)Reference
[Removing the Fixing Main Heater/the Fixing Sub Heater]
9.7.4.2 Removing the Fixing Roller
0014-0187
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
1) Remove the fixing roller [1].
- 2 C-rings [2]
- 2 gears [3]
- 2 bearings [4]
- 2 fixing roller heat insulating bushes [5]
- 1 holder [6]
Points to Note When Mounting the Fixing Roller
- The orientation for mounting the gears [3] and the heat-insulating bushes
[5] is specified. Mount them in the orientation shown in the below figure.
- When attaching the photosensitive drum, be sure to do it with the shielding
sheet attached. Remove the shielding sheet after you finished attaching it.
F-9-70
9.7.4.3 After Replacing the Fixing Roller
0014-0188
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / image-
PRESS C1+
- Apply grease (Molykote HP-300; CK-8012) to the inner diameter area [1]
and the outer diameter area [2] of the bushings for about 20 mg, so that to
make white coating in assigned areas.
Purpose: to avoid abnormal sound
The orientation for mounting the gears is specified. Mount them in the ori-
entation shown in the below figure.
F-9-71
[2]
[1]
[1]
[1]
[2]
[2]
[2]
[2]
[3]
[3]
[4]
[5]
[5]
[6]
[6]
[1]
[2]
[2]
[3]
[3]
[4]
[4]
[5]
[5]
[6]
[1]
[2]