Canon imagePRESS C1 Service Manual - page 194
Chapter 2
2-100
F-2-388
10) Attach the platen glass and glass retainer in the procedure opposite to the removal procedure.
11) Make sure that the environmental switch [1] located on the rear left side of the main unit is turned ON.
F-2-389
12) Connect the host machine's 2 power plugs (back, left) to 2 separate power supply systems; then, turn on the main power switch.
2.13 Installing the Deck Heater
2.13.1 Checking the Contents (Heater PCB-F1)
0013-7786
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+
Every components of the cassette heater unit (heater PCB-F1) are supplied as service parts, so have the following parts on hand.
Tighten the screw [3] while pushing the lens heater [1] in the direction of
the embossed section [2]. Be careful so that the claw [4] of the heater is not
removed. Make sure that the bottom of the heater firmly contacts with the
frame.
[2]
[3]
[4]
[1]
[1]
[2]
[3]
[4]
ON
ON
[1]