Canon imagePRESS C1 Service Manual - page 208
Chapter 2
2-114
F-2-423
10) Insert the AC cord [1] into the hole of the cord mount [2], and then secure the ground cable [3] to the cord mount using a screw with toothed washer [4].
11) Secure the AC cord [1] to the cord mount using a screw [5] with flat spring.
F-2-424
12) Hang the left-hand hook [1], and then secure the cord mount [3] to the host machine using two binding screws (M4X4) [2].
13) Connect the connector of the AC cord to the connector [4] on the host machine.
F-2-425
14) Install the rear-lower cover of the host machine using eight screws.
15) Reattach the exterior covers of the paper deck in the following sequence:
[1] Top cover (Take care not to have cables caught.) (M4X8: 2pcs.)
[2] Front-upper cover (Insert the connector.)(M4X8: 3pcs.)
[3] Rear cover (M3X8: 2pcs., M4X8:4 pcs.)
[4] Right cover (M4X8: 3pcs.)
16) Manually slide the paper deck to the left to place it aside of the host machine.
17) Stick the power supply label [1] on the rear panel of the paper deck.
[1]
[2]
[4]
[3]
[2]
[1]
[5]
[2]
[3]
[1]
[4]