Canon imagePRESS C1 Service Manual - page 576
Chapter 9
9-39
6) Open the fixing upper unit [1] in the direction of the arrow.
- 2 clamps [2]
- 2 edge saddles [3]
- 5 connectors [4]
F-9-63
7) Disconnect the 2 connectors [1] and remove the 2 screws [2].
F-9-64
8) Push the 2 screws [1] in the direction of the arrow [A], and then move
them in the direction of the arrow [B] to remove.
F-9-65
9) While pulling the belt tension area [1] in the direction of the arrow [A],
pull out the belt [2] in the direction of the arrow [B].
F-9-66
10) Hold the gear of the fixing belt unit [2], turn the fixing belt unit [1] in the
direction of the arrow [A], and then pull it out in the direction of the arrow
[B].
F-9-67
Points to Note When Mounting the Fixing Belt Unit
- Before mounting the fixing belt unit, turn the gear [2] so that the holding
area [1] of the steering roller moves to the position shown in the figure
[4]
[4]
[4]
[2]
[3]
[1]
[2]
[2]
[1]
[A]
[B]
[1]
[1]
[A]
[B]
[1]
[2]
[A]
[B]
[1]
[A]
[B]
[2]