Canon imagePRESS C1 Service Manual - page 1061
Chapter 16
16-164
ORG-LGL
Set the special paper size which cannot be recognized by DF.
2
Setting range
0: LEGAL-R
1: Bolivia OFFICIO-R
2: Argentina OFFICIO-R
3: Argentina LEGAL-R
4: Mexico OFFICIO-R
Standard value
0
ORG-LTR
Set the special paper size which cannot be recognized by DF.
2
Setting range
0: LETTER [Factory setting value / Value after RAM clear]
1: EXECUTIVE
2: Korean government office paper
3: Argentina LETTER
4: Government LETTER
Standard value
0
UI-COPY
Make a setting to switch the display in the copy screen in the control panel.
2
Setting range
0: Hide the copy screen.
1: Do not hide the copy screen.
Standard value
1
UI-BOX
Restrict the box screen display in the control panel.
2
Setting range
0: BOX function unavailable (Unavailable for PDLtoBox)
1: BOX function available
2: BOX function available with restriction (Unavailable for LUI and RUI, but available for
PDLtoBOX)
Standard value
1
UI-SEND
Select 'hide' or 'not hide' of the transmission screen in the control panel.
2
Setting range
0: Hide
1: Do not hide
Standard value
1
UI-FAX
Select 'hide' or 'not hide' of the FAX screen in the control panel.
2
Setting range
0: Hide
1: Do not hide.
Standard value
1
TMC-SLCT
Switch the coefficient used for error diffusion.
Use this mode to increase dot stability and granularity so that pitch unevenness or course image
that occurred on an image can be made invisible.
2
Setting range
0: Normal
1: Low granularity / low stability
2: High granularity / high stability
Standard value
0
DEVL-VTH
Set the threshold value of image density to make a decision to perform the discharging sequence
for continuous printing of a low density image, which is performed as measures for a spot or
course image. Use of this mode must be avoided as much as possible when the machine has been
operating normally.
2
Setting range
1 to 5 (Unit: %)
Standard value
2
The setting value becomes valid after the main power switch is turned OFF/ON.
FTPTXPN
Specify a port number (FTP) of the SEND destination.
2
Setting range
0 to 65535 (16 bit)
Standard value
21
COPIER>OPTION>BODY
Subheading Contents
Level