Canon imagePRESS C1 Service Manual - page 545
Chapter 9
9-8
9.1.6 Fixing Roller/Belt Drive Control
0012-6437
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+
The diagram shows the configuration of the control system of the fixing roller and fixing belt drive system.
Fixing motor (M38) is driven at 285 mm/sec for constant velocity print, and 95 mm/sec for 1/3 print.
At warm-up and print (in the state that the fixing roller is driven), the fixing belt is pressed by the fixing roller. In this case, the fixing belt is driven by the fixing
motor (M38). In a stand-by state (in the state that the fixing roller is stopped), the fixing belt is separated from the fixing roller. In this case, the driving source of
the fixing belt is switched to the fixing belt drive motor (M36).
The fixing belt is driven in the stand-by mode in order to control temperature. It is driven at low speed (about 30-40 mm/sec) to prevent belt displacement.
F-9-7
[1] Fixing roller
[2] Fixing belt
M36: Fixing belt drive motor
M38: Fixing motor
UN4: Fixing driver PCB
FIX_MTR_ON*: Fixing motor ON signal
FIX_MTR_LOCK*: Fixing motor lock signal
FIX_MTR_BRAKE: Fixing motor brake signal
MOTOR_ON: Fixing belt drive motor ON signal
MOTOR_LOCK: Fixing belt drive motor lock signal
FIX_MTR_GAIN: Fixing motor speed gain signal
UN4
J3308
1 2 3 4 5 6 7
GND
FIX_MTR_+5V
FIX_MTR_ON*
FIX_MTR_LOCK*
FIX_MTR_BRAKE
FIX_MTR_GAIN
FIX_MTR_CLK
J3316
1 2 3 4 5
+24V
GND
MOTOR_ON
MOTOR_LOCK
M38
M36
[1]
[2]