Canon imagePRESS C1 Service Manual - page 134
Chapter 2
2-40
2.2.12 Mounting the Balancing Cylinder
0020-4620
imagePRESS C1+ (Printer) / imagePRESS C1+
1) Take out the balancing cylinders from the attached packing box.
2) Remove the developing assembly cover [1].
- 1 screw [2]
F-2-82
3) Hold the gear at the developing assembly [1], and manually turn the de-
veloping rotary [2] counterclockwise, then with the balancing cylinder
upward, fix [A] and [B] aligned as instructed in the figure.
F-2-83
F-2-84
4) Open the 2 developing assembly fixing arms [1].
- 2 screws [2]
F-2-85
5) Attach the balancing cylinder [1] to the developing rotary. Make sure that
the pin [2] at the Balancing Cylinder is found in the hole located at the
backside of the developing rotary [3].
- Balancing cylinder [1], is a parts to maintain the balance in the inner
Rotary. Make sure to install it before installing the developing assembly.
- The position for Balancing cylinder [1] installation is in the area with no
toner supply.
C
M
Y
L
Bk
[1]
Balancing Cylinder
[2]
[1]
[1]
[2]
In the case of turning the developing rotary, make sure that the developing
assembly fixing arm is fixed with the screw.
In the case of attaching the balancing cylinder, make sure not to bump into
the ATR sensor shutter [1].
[A]
[B]
[2]
[1]
[2]
[1]
[1]